Pemanfaatan Plastik Low Density Polyethylene (LDPE) dan Arang Tempurung Kelapa Sebagai Substitusi Sebagian Aspal Pada Lapisan AC-WC

Wesli MT; Mhd. Afrizam Syahputra; Said Jalalul Akbar; Muthmainnah Muthmainnah

doi:10.29103/tj.v14i2.1149

Pemanfaatan Plastik Low Density Polyethylene (LDPE) dan Arang Tempurung Kelapa Sebagai Substitusi Sebagian Aspal Pada Lapisan AC-WC

Wesli MT, Mhd. Afrizam Syahputra, Said Jalalul Akbar, Muthmainnah Muthmainnah

Abstract

Abstrak

Sampah plastik saat ini sudah menjadi suatu permasalahan yang sangat umum di lingkungan hidup, upaya pengurangan dan pencegahan telah banyak dilakukan, namun hasil yang diperoleh tidak sesuai dengan pertumbuhan dan penggunaan yang terus meningkat khususnya plastik yang tidak terkelola dengan baik. Salah satu upaya yang harus dilakukan untuk mengurangi limbah plastik adalah dengan memanfaatkan viscoelastisity plastik dan dikombinasikan dengan karbon arang tempurung kelapa serta material tersebut akan dimanfaatkan sebagai bahan pengganti sebagian aspal pada lapisan AC-WC. Tujuan penelitian ini untuk mengetahui besarnya variasi campuran plastik LDPE dan arang tempurung kelapa yang dapat dimanfaatkan untuk memenuhi parameter marshall pada lapisan AC-WC. Metode yang digunakan pada penelitian ini adalah metode eksperimental yang bersifat deduktif. Hasil penelitian yang telah dilakukan dengan kadar variasi plastik LDPE 5%, 10%, 15% dikombinasikan dengan arang tempurung kelapa 5%, 10% dan 15% hasil yang diperoleh dari pengujian marshall untuk variasi 10%, VIM dan VFA tidak memenuhi, variasi 20% VIM dan VFA tidak memenuhi dan variasi 30% hanya flow yang tidak memenuhi spesifikasi yang disyaratkan oleh Bina Marga Tahun 2018 Revisi II, sehingga dapat disimpulkan bahwa plastik LDPE dan arang tempurung kelapa tidak dapat dimanfaatkan sebagai substitusi sebagian aspal pada variasi 10%, 20% dan 30%, hal tersebut disebabkan karena seluruh variasi campuran tidak memenuhi parameter marshall.

Kata kunci: Arang Tempurung Kelapa, Plastik LDPE, Parameter Marshall, Substitusi Sebagian Aspal

Abstract

Plastic waste has now become a very common problem in the environment, Many reduction and prevention efforts have been carried out, but the results obtained are not in line with the growth and increasing use, especially plastics that are not managed properly. One of the efforts that must be made to reduce plastic waste is to utilize the viscoelasticity of the plastic and combined with coconut shell charcoal carbon and the material will be used as a substitute for part of the asphalt in the AC-WC layer. The purpose of this study was to determine the magnitude of variations in the mixture of LDPE plastic and coconut shell charcoal that can be used to meet marshall parameters in the AC-WC layer. The method used in this study is an experimental method that is deductive. The results of studies that have been carried out with LDPE plastic variation levels of 5%, 10%, 15% combined with coconut shell charcoal 5%, 10% and 15% results obtained from marshall testing for 10% variation, VIM and VFA are not eligible, 20% variation in VIM and VFA are not qualified and 30% variation only flow does not meet the specifications required by Bina Marga 2018 Revision II, so it can be concluded that LDPE plastic and coconut shell charcoal cannot be used as a partial substitution of asphalt at variations of 10%, 20% and 30%, this is because the entire variation of the mixture does not meet the parameters of marshalls.

Keywords: Coconut Shell Charcoal, LDPE Plastic, Marshall Parameters, Partial Substitution

Keywords

Coconut Shell Charcoal, LDPE Plastic, Marshall Parameters, Partial Substitution

Full Text:

PDF

References

A. Al-Mansob, R., Ismail, A., A. Algorafi, M., Hafezi, M.H., Baghini, M.S., 2013. Comparison between Mixtures of Asphalt with Palm Oil Shells and Coconut Shells as Additives. J. Kejuruter. 25, 25–31. https://doi.org/10.17576/jkukm-2015-25-04

Akinpelu, M., Dahunsi, B.I., Olafusi, O., Awogboro, O., Quadri, A., 2013. Effect of polythene modified bitumen on properties of hot mix asphalt. ARPN J. Eng. Appl. Sci. 8, 290–295.

Dubey, P., 2019. Utilization of Low Density Plastic Waste in Construction of Flexible Pavement with a Partial Replacement of Bitumen. Int. J. Res. Appl. Sci. Eng. Technol. 7, 1989–1996. https://doi.org/10.22214/ijraset.2019.4362

Erni, D.S., Rifqi, M.G., Amin, M.S., 2021. Effect of Low Density Polyethylene Plastic Waste Addition on Laston Mixture Characteristics AC-WC. J. Appl. Civ. Eng. Infrastruct. Technol. 2, 7–13.

Fatmawati, L., Ariyanto, A.S., Supriyadi, P., n.d. The Effect of Using Low Density Polyethylene (LDPE) and High Density Polyethylene (HDPE) Plastic Waste in the Asphalt Concrete Wearing Course (AC-WC) Comparsion of Marshall Characteristics.

Genet, M.B., Sendekie, Z.B., Jembere, A.L., 2021. Investigation and optimization of waste LDPE plastic as a modifier of asphalt mix for highway asphalt: Case of Ethiopian roads. Case Stud. Chem. Environ. Eng. 4, 100150.

Hermanus, G., Kaseke, O.H., Jansen, F., 2015. Study of Performance Differences in Hot Paved Mixtures Between Types of Thin Layers of Thin Asphalt Concrete-Coated Wear (Hrs-Wc) Graded Singles with Semi-Paralleled Ones 7.

Heydari, S., Hajimohammadi, A., Javadi, N.H.S., Khalili, N., 2021. The use of plastic waste in asphalt: A critical review on asphalt mix design and Marshall properties. Constr. Build. Mater. 309, 125185.

Jeffry, S.N.A., Putra Jaya, R., Abdul Hassan, N., Yaacob, H., Mahmud, M.Z.H., Al-Saffar, Z.H., 2022. The influence of nano-carbon from coconut shell ash as modifier on the properties of bitumen. Road Mater. Pavement Des. 23, 770–786.

Kakisina, E.M., Makmur, A., Salim, F.D., 2020. Influence of LDPE Plastic Waste on Asphalt Mixture Soaked in Sea Water, in: IOP Conference Series: Earth and Environmental Science. IOP Publishing, p. 012026.

Kementrian Pekerjaan Umum Ditjen Bina Marga, 2018. General Specifications of Bina Marga.

Lubis, A.S., Muis, Z.A., Siregar, N.A., 2020. The effects of low-density polyethylene (LDPE) addition to the characteristics of asphalt mixture, in: IOP Conference Series: Earth and Environmental Science. IOP Publishing, p. 012063.

Mashuri, M., 2019. Effect of Coconut Shell Charcoal Powder Use And Variation In Impact Amount On Asphalt Concrete Mixture Characteristics. MEKTEK 10.

Molvi, A.T., Singh, S., 2022. Experimental Investigation of Coconut Shell Charcoal Ash in Bituminous Concrete. EasyChair.

Norhafizah, M., Hainin, M.R., 2016. The effect of coconut shell on engineering properties of porous asphalt mixture. J. Teknol. 78.

Nur, M.F., Imananto, E.I., Prajitno, A., 2017. Utilization of coconut shell charcoal powder as an added material with stone ash filler to improve the performance of asphalt concrete characteristics (AC-WC). SONDIR.

Othman, A.M., 2010. Effect of low-density polyethylene on fracture toughness of asphalt concrete mixtures. J. Mater. Civ. Eng. 22, 1019–1024.

Purwaningrum, P., 2016. Efforts to reduce the generation of plastic waste in the environment. Indonesian. J. Urban Environ. Technol. 8, 141–147.

Ramadhansyah, 2019. Performance of Charcoal Coconut Shell Ash in the Asphalt Mixture under Long Term Aging. Int. J. Recent Technol. Eng. 8, 383–387. https://doi.org/10.35940/ijrte.C1010.1183S319

Ramadhansyah, P.J., Masri, K.A., Awang, H., Satar, M., Hainin, M.R., Norhidayah, A.H., Warid, M.M., Yaacob, H., Juraidah, A., 2020. Short term aging effect of asphaltic concrete incorporating charcoal ash from coconut shell, in: IOP Conference Series: Materials Science and Engineering. IOP Publishing, p. 012036.

Razak, B.A., Erdiansa, A., 2016. Characteristics of AC-WC Mixture with the Addition of Low Density Polyethylene (LDPE) Plastic Waste. INTEK J. Penelit. 3, 8–14.

Refiyanni, M., Chaira, C., 2021. Characteristics of Mixed Porus Asphalt with Combination of LDPE, CPO and PEN 60/70. Int. J. Eng. Sci. Inf. Technol. 1, 19–24.

Setyarini, N.L., Tajudin, A., 2019. Characteristics of Asphalt Concrete Mixed Using Aggregates Coated by Low Density Polyethilene (LDPE) Plastic Waste, in: 11th Asia Pacific Transportation and the Environment Conference (APTE 2018). Atlantis Press, pp. 12–15.

Shbeeb, M.T., 2007. The use of polyethylene in hot asphalt mixtures. Am. J. Appl. Sci. 4, 390–396.

Siswadi, A., Saleh, S.M., Darma, Y., 2020. The use of Sabang mountain rocks and substitution of LDPE in the AC-WC mixture with dry method, in: IOP Conference Series: Materials Science and Engineering. IOP Publishing, p. 012004.

Sukirman, S., 2003. Hot Mix Asphalt Concrete.

Susilowati, A., Wiyono, E., Pratikto, P., 2021. Utilization of plastic waste as an added material in hot mix asphalt concrete. Build Rekaprima Maj. Ilm. Puffer. Sos Engineering. and Hum. 7, 15–23.

Sutandar, S., Juniardy, F., Supriyadi, A., Setyabudi, G., Azwansyah, H., Aryanto, A., 2022. Utilization of LDPE Plastic Waste for Mixed AC-WC Asphalt. Int. J. Sci. Adv. 3. https://doi.org/10.51542/ijscia.v3i5.3

Syammaun, T., Meillyta, Yati, R., 2020. Effect of coconut-shell ash as filler and plastic bottle as substitution of porous asphalt mixture. IOP Conf. Ser. Mater. Sci. Eng. 821, 012015. https://doi.org/10.1088/1757-899X/821/1/012015

Syammaun, T., Rachman, F., Hidayat, R., 2019. Characteristic of coconut-shell ash as filler and LDPE plastic waste as substitution materials of porous asphalt mixtures. Int. J. Recent Technol. Eng. IJRTE 8, 340–344.

Tamalkhani Syammaun, Firmansyah Rachman, Rifki Hidayat, 2019. Characteristic of Coconut-Shell Ash as Filler and LDPE Plastic Waste as Substitution Materials of Porous Asphalt Mixtures. Int. J. Recent Technol. Eng. 8, 340–344. https://doi.org/10.35940/ijrte.C1003.1183S319

Tanton, E., Tajudin, A.N., 2020. Mechanical characteristics of upper laston mixture with the addition of carbon fiber. JMTS J. Mitra Tek. Sipil 3, 613.

Utomo Nugroho, N.-, 2018. Utilization of Coconut Shell Waste as Filler Material in Road Pavement Mixture.

Yacoob, H., Jaya, R.P., Madzaili, A.H., Hassan, N.A., Hainin, M.R., Nazri, F.M., 2017. Stability properties of asphalt mixture incorporating coconut shell. J. Fundam. Appl. Sci. 9, 16–24.

DOI: https://doi.org/10.29103/tj.v14i2.1149